Description

High strength and low loss 6GHz Coaxial cable, 2 meters in length, assembled with connectors N male / N male tightened with hardware (Clamped).

Coaxial cables, normally used to connect the access point to the antennas, are a critical component because transferring the RF signal at very high frequencies, up to 5.8 GHz, to the antenna to be radiated on air; if the cable is not well built or is of poor quality, can lead to significant problems.

It 'must use quality cables and Clamped connectors (tightened with hardware), such as cables SELIT CV400-NM-NM-x, in order to minimize potential problems like:

• Connection no more reliable after some mechanical stress, especially after a few twists and especially if the connectors are "Crimp type" and not to "Clamp Type" tighten with hardware.

• Bad VSWR, stable or intermittent (for false contacts), which can damage the radio card or, worse, de-sensitize his front end.

Cables SELIT CV400-NM-NM-x, are built using low-loss coaxial cable with a diameter of 10mm and N-type male connectors with locking screw to ensure good contact stable over time.

In order to keep the electrical and mechanical caracteristics, we recommend caution in the handling of the cables avoiding excessive twisting, too close bending and, however, all stresses that can alter the concentricity of the cable.

When used in outdoor environment is recommended to cover the connectors with self-vulcanizing tape and good quality isolation tape to ensure a perfect seal against infiltration of water and moisture.

The coaxial cables SELIT CV400-NM-NM-x, handled and installed by following these simple rules, ensuring a transfer of the RF signal from the radio to the antenna with minimum loss and maximum reliability .

Main Features

• N male Clamp connectors tightened with hardware for high reliability

• Good VSWR and low Insertion Loss

• Frequency up to 6GHz

Applications

• Radio to Antenna RF connection

• Radio/Splitter and Splitter/Antenna connection

• General purpose RF connection up to 6GHz

Technical Parameters

Elettrici- Electrical 

Cavo Tipo - Cable Type

CDF/LMR400  Bassa perdita - Low Loss CDF/LMR 400 Type

Impedenza - Impedance

50 Ohm

Range di frequenza - Frequency Range

DC - >6GHz

Connettore 1 Tipo - Connector 1 type

N maschio a serrare - N male Clamp

Connettore 2 Tipo - Connector 2 type

N maschio a serrare - N male Clamp

Perdita di passaggio -Insertion Loss

<1,3dB (Tipico - Typical)

Meccanici - Mechanical 

Diametro cavo coassiale - Coaxial cable Diameter

10,3mm Esterno - External

Lunghezza - Lenght

2 metri - 2 meters 

Raggio minimo di curvatura - Minimum Bend radius

25cm

Ambiente Operativo - Operating Environment

Indoor / Outdoor

Peso - Weight

0,4Kg